Payload Adapter plate
To exchange between different damping plate mounting setups the fasteners attached to the Adapter_DP must be changed. Each drone has four (4) of these adapters located in the following positions under the bottom plate:
As referenced in the last image, there are two types: I and II. One is a mirror of the other, and they should be located in the same way as the reference imagen.
For exchange the fasteners, the Adapter_DP must be unattached from the drone, so it is important to unscrew the following fasteners using a screwdriver HEX2,5:
At the moment the Adapter DP is unattached, there must be placed the specific fasteners for each configuration, depending on the required Damping Plate. As reference, check the table below:
| DAMPING PLATE | SCREW (FLAT) | SPACER | NUM_IMAGE |
| AEVO BS | M4 X 8 | M4 X 35 | 1 |
| DP Pro | M3 X 8 | M3 X 35 | 2 |
| Rail | M2,5 X 8 | N/A | 3 |
- AEVO BS Damping Plate. 2) Damping Plate PRO Gremsy. 3) Rails.